Tesker Model 440E 2-Die

More Muscle for Tougher Alloys

Designed for greater strength and rigidity, the Tesker Model 440 2-Die Thread Rolling Machine provides cost-effective dependability in challenging applications

Tesker Model 440E 2-Die Machine Specifications:
Type Infeed & Thrufeed
Capacity 4-1/2"
Rolling Pressure Adjustable to 125,000 lbs.
Spindle Drive 60 HP (variable)/40 HP (4-speed)
Hydraulic 5 HP, Capacity 50 Gal
Coolant 1/2 HP, Capacity 120 Gal
Maximum Diameter 9"
Maximum Face Width 8"
Spindle Size 3" (other sizes available)
Spindle Speeds Variable or 4-speed Manual
Spindle RPM 10 - 170 (other speeds available)
Floor Dimensions
Width 92"
Length 102"
Height 68"
Weight 16,000 lbs.
All models wired to NFPA 79 standards for operation on 240 or 480 volt, 3 phase, 60hz. Other voltages available at additional cost.
Specifications subject to change without notice.
Please be advised that fixturing and additional guards may be needed, depending on job being rolled. Tesker Manufacturing Corporation assumes no liability for fixturing or guards designed, manufactured or installed by anyone other than Tesker Manufacturing Corporation.

Tesker Model 440E 2-Die Standard Equipment

+Hydraulic Slow Release Valve

+Servo Drive

+Spindle RPM Tachometer

+Versa III Auto Oil Lubrication System

Tesker Model 440E 2-Die Available Options

+Thread Length Control Limit Switch

+Radial Die Line-Up Coupling

+Front "L" Support including Front Bar Feed Fixture

+Spring Loaded Rear Stop Assembly with Base

+Part Hold Down with Spring Loaded Stop

+Tie Arm Hydraulic Stop Block Assembly

+Enclosed Toe-in Indicator

+Outboard Roller Supports (1set/2pcs)

+Center Stands (1 set/2 pcs)

+Center Support Tube (1 needed for each size)

+Upper Support Holder

+Feeding and Receiving Fixtures