Tesker Model 200E 2-Die

High Performance without the High Price

The Tesker Model 200E is an economical 2-Die Thread Rolling Machine with heavy-duty, high-torque rollers built for easy, long-lasting operation.

Tesker Model 200E 2-Die Machine Specifications:
Type Infeed & Thrufeed
Capacity 2"
Rolling Pressure Adjustable to 24,000 lbs.
Motors
Spindle Drive 15 HP
Coolant 1/4 HP, Capacity 50 Gal
Dies
Maximum Diameter 6"
Maximum Face Width 3-1/2"
Spindle Size 1-1/2" (other sizes available)
Spindle Speeds Variable
Spindle RPM 45 - 200 (other speeds available)
Floor Dimensions
Width 56"
Length 66"
Height 62"
Weight 3,000 lbs.
All models wired to NFPA 79 standards for operation on 480 volt, 3 phase, 60 hz. Other voltages available at additional cost.
Specifications subject to change without notice.
Please be advised that fixturing and additional guards may be needed, depending on job being rolled. Tesker Manufacturing Corporation assumes no liability for fixturing or guards designed, manufactured or installed by anyone other than Tesker Manufacturing Corporation.

Tesker Model 200E 2-Die Standard Equipment

+Spindle RPM Tachometer

+Tie Arm Hydraulic Stop Block Assembly

Tesker Model 200E 2-Die Available Options

+Servo Drive

+Thread Length Control Limit Switch

+Radial Die Line-Up Coupling

+Front "L" Support including Front Bar Feed Fixture

+Spring Loaded Rear Stop Assembly with Base

+Part Hold Down with Spring Loaded Stop

+Tie Arm Hydraulic Stop Block Assembly

+Versa III Auto Oil Lubrication System

+Oil 1 Shot Manual Lubrication Unit

+Enclosed Toe-in Indicator

+Outboard Roller Supports (1set/2pcs)

+Center Stands (1 set/2 pcs)

+Center Support Tube (1 needed for each size)

+Upper Support Holder

+Feeding and Receiving Fixtures