Tesker Model 840 2-Die

With 24-inch diameter capacity and up to 650,000 lbs. of rolling pressure, the Tesker Model 840 2-Die Thread Rolling Machine is impressive with it's capabilities.

Tesker Model 840 2-die Machine Specifications:
Type Infeed & Thrufeed
Capacity 24"
Rolling Pressure Adjustable to 650,000 lbs.
Motors
Spindle Drive 100 HP
Hydraulic 30 HP, Capacity 100 Gal
Coolant 3/4 HP, Capacity 200 Gal
Dies
Maximum Diameter 16"
Maximum Face Width 15"
Spindle Size 5-1/2" (other sizes available)
Spindle Speeds Variable
Spindle RPM 2 - 50 (other speeds available)
Floor Dimensions
Width 216"
Length 255"
Height 106" with crane
Weight 96,000 lbs.
All models wired to NFPA 79 standards for operation on 240 or 480 volt, 3 phase, 60hz. Other voltages available at additional cost.
Specifications subject to change without notice.
Please be advised that fixturing and additional guards may be needed, depending on job being rolled. Tesker Manufacturing Corporation assumes no liability for fixturing or guards designed, manufactured or installed by anyone other than Tesker Manufacturing Corporation.

Tesker Model 840 2-die Standard Equipment

+Front "L" Support including Front Bar Feed Fixture

+Hydraulic Slow Release Valve

+Servo Drive

+Spindle RPM Tachometer

+Spring Loaded Rear Stop Assembly with Base

+Versa III Auto Oil Lubrication System

Tesker Model 840 2-die Available Options

+Radial Die Line-Up Coupling

+Enclosed Toe-in Indicator

+Center Stands (1 set/2 pcs)

+Center Support Tube (1 needed for each size)

+Air Balancer Jib Crane

+Feeding and Receiving Fixtures