Tesker Model 236 2-Die

Easy to Use. Tough to Beat.

The Tesker Model 236 2-Die Thread Rolling Machine offers increased rolling pressure, added horsepower and enhanced ease of use.

Tesker Model 236 2-Die Machine Specifications:
Type Infeed & Thrufeed
Capacity 2-1/2"
Rolling Pressure Adjustable to 60,000 lbs.
Motors
Spindle Drive 40 HP
Hydraulic 3 HP, Capacity 30 Gal
Coolant 1/4 HP, Capacity 50 Gal
Dies
Maximum Diameter 7-5/8"
Maximum Face Width 6"
Spindle Size 2-1/2" (other sizes available)
Spindle Speeds Variable
Spindle RPM 50 - 200 (other speeds available)
Floor Dimensions
Width 77"
Length 87"
Height 67"
Weight 8,500 lbs.
All models wired to NFPA 79 standards for operation on 240 or 480 volt, 3 phase, 60hz. Other voltages available at additional cost.
Specifications subject to change without notice.
Please be advised that fixturing and additional guards may be needed, depending on job being rolled. Tesker Manufacturing Corporation assumes no liability for fixturing or guards designed, manufactured or installed by anyone other than Tesker Manufacturing Corporation.

Tesker Model 236 2-Die Standard Equipment

+Spindle RPM Tachometer

Tesker Model 236 2-Die Available Options

+Servo Drive

+Thread Length Control Limit Switch

+Radial Die Line-Up Coupling

+Front "L" Support including Front Bar Feed Fixture

+Spring Loaded Rear Stop Assembly with Base

+Part Hold Down with Spring Loaded Stop

+Tie Arm Hydraulic Stop Block Assembly

+Versa III Auto Oil Lubrication System

+Oil 1 Shot Manual Lubrication Unit

+Enclosed Toe-in Indicator

+Outboard Roller Supports (1set/2pcs)

+Center Stands (1 set/2 pcs)

+Center Support Tube (1 needed for each size)

+Upper Support Holder

+Spindle RPM Tachometer

+Feeding and Receiving Fixtures