Tesker Model 230 2-Die

Heavy-Duty Rolling at a Price That’s Light on Your Budget

Tough yet affordable, the Tesker Model 230 2-Die Thread Rolling Machine cost-effectively provides thread rolling for a variety of parts. 

Tesker Model 230 2-Die Machine Specifications:
Type Infeed & Thrufeed
Capacity 2-1/2"
Rolling Pressure Adjustable to 40,000 lbs.
Motors
Spindle Drive 30 HP
Hydraulic 2 HP, Capacity 30 Gal
Coolant 1/4 HP, Capacity 50 Gal
Dies
Maximum Diameter 7-5/8"
Maximum Face Width 6"
Spindle Size 2-1/2" (other sizes available)
Spindle Speeds Variable
Spindle RPM 60 - 210 (other speeds available)
Floor Dimensions
Width 77"
Length 87"
Height 67"
Weight 6,000 lbs.
All models wired to NFPA 79 standards for operation on 240 or 480 volt, 3 phase, 60 hz. Other voltages available at additional cost.
Specifications subject to change without notice.
Please be advised that fixturing and additional guards may be needed, depending on job being rolled. Tesker Manufacturing Corporation assumes no liability for fixturing or guards designed, manufactured or installed by anyone other than Tesker Manufacturing Corporation.

Tesker Model 230 2-Die Standard Equipment

+Spindle RPM Tachometer

Tesker Model 230 2-Die Available Options

+Servo Drive

+Thread Length Control Limit Switch

+Radial Die Line-Up Coupling

+Front "L" Support including Front Bar Feed Fixture

+Spring Loaded Rear Stop Assembly with Base

+Part Hold Down with Spring Loaded Stop

+Tie Arm Hydraulic Stop Block Assembly

+Versa III Auto Oil Lubrication System

+Oil 1 Shot Manual Lubrication Unit

+Enclosed Toe-in Indicator

+Outboard Roller Supports (1set/2pcs)

+Center Stands (1 set/2 pcs)

+Center Support Tube (1 needed for each size)

+Upper Support Holder

+Feeding and Receiving Fixtures