Tesker Model 215 2-Die

Quality Built - Cost Effective

When accuracy, speed and repeatability are a must, the Tesker Model 215 will fit the bill.

Tesker Model 215 2-Die Machine Specifications:
Type Infeed & Thrufeed
Capacity 2"
Rolling Pressure Adjustable to 35,000 lbs.
Motors
Spindle Drive 20 HP
Hydraulic 3 HP, Capacity 45 Gal
Coolant 1/4 HP, Capacity 50 Gal
Dies
Maximum Diameter 6"
Spindle Speeds 4-1/2"
Spindle Size 2" (other sizes available)
Spindle Speeds Variable
Spindle Size 40-180 (other speeds available)
Floor Dimensions
Width 56"
Length 84"
Height 51"
Weight 4,500 lbs.
All models wired to NFPA 79 standards for operation on 240 or 480 volt, 3 phase, 60 hz. Other voltages available at additional cost.
Specifications subject to change without notice.
Please be advised that fixturing and additional guards may be needed, depending on job being rolled. Tesker Manufacturing Corporation assumes no liability for fixturing or guards designed, manufactured or installed by anyone other than Tesker Manufacturing Corporation.

Tesker Model 215 2-Die Standard Equipment

+Spindle RPM Tachometer

Tesker Model 215 2-Die Available Options

+Servo Drive

+Thread Length Control Limit Switch

+Radial Die Line-Up Coupling

+Front "L" Support including Front Bar Feed Fixture

+Spring Loaded Rear Stop Assembly with Base

+Part Hold Down with Spring Loaded Stop

+Enclosed Toe-in Indicator

+Outboard Roller Supports (1set/2pcs)

+Center Stands (1 set/2 pcs)

+Center Support Tube (1 needed for each size)

+Upper Support Holder

+Feeding and Receiving Fixtures